Radio Shack CID 2905 - Manual (Page 15)

15 Preparation
4. Set your answering machine to
answer after two or more rings. This
gives the Caller ID time to record the
call information that the phone com-
pany sends between the first and
second rings.
MOUNTING THE CID
You can place the CID on a flat surface, or
you can mount it on a wall.
Follow these steps to mount the CID on a
wall.
1. Select a location near the phone line
jack, then use the round holes in the
mounting bracket as a template to
mark the mounting screw locations
on the wall.
2. Drill two 1 / 8 -inch (3.5 mm) holes in the
wall at the marked locations.
3. While holding the bracket against the
wall, thread a screw (not supplied)
through each hole in the bracket, then
tighten the screws.
4. Align the slots on the back of the
Caller ID with the holes on the
bracket. Gently slide the CID down-
ward to secure it.