Royal Leisure WINNIPEG 6 - Manual

Winnipeg 6
Check list
Polycotton Flysheet
Inner Tents x 2
Poles
Pegs
Pole Sleeves
Drop in Groundsheet
Canopy
Repair kit
Instructions
Thank you for purchasing a Royal Winnipeg 6 tent. It is advised that you check and erect
your tent before use. It is strongly advised that you “Weather your tent” before use. This
involves erecting the tent (as per the instructions below) and then either leaving it up to get
wet or hosing it down with a hose pipe. This allows you to see if there are any problems.
Enclosed is a repair kit, in the kit is a small tube of seam seal, which can be used on the
inside of the tent seams (not to be used on the bedroom compartment material). If you tent
should have a missing part or any other issue please contact the dealer you purchased it
from.
On arrival at you camping area please make sure that the ground is free from any sharp
objects or other objects that may damage the tent.
Assemble spring-adjoined poles by inserting each pole-end into the end of the next pole.
Ensure that shaped pole ends are correctly aligned before joining them. They do not require
force. Lay them parallel on the ground.