Rockford Fosgate Mono Amplifiers - Manual (Page 12)

12
S
PECIFICATIONS
Specifications subject to change without notice
MODEL- PRO bd1000P bd1500P
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4
Ω Load Mono
500 Watts x 1 750 Watts x 1
2 Ω Load Mono 1000 Watts x 1 1500 Watts x 1
Dimensions: (with Endbell)
Height 2.4" (6.1cm) 2.4" (6.1cm)
Width 9.8" (24.89cm) 9.8" (24.89cm)
Length 13.35" (33.96cm) 18.35" (46.74cm)
Battery Fuse Rating (Amp) 100A 1500A
(External to Amplifier) Not Supplied Not Supplied
Fuse Type AGU AGU
Signal-to-Noise Ratio >90dB A-weighted
Crossover Slope 24dB/octave Butterworth
Crossover Frequency variable LP (Low Pass) from 50Hz to 250Hz
Frequency Response 20Hz to 20kHz ±0.5dB
Bandwidth 20Hz to 200kHz ±3dB
Damping Factor @ 4
Ω (at output connector )
>200
Slew Rate 30 Volts/ms
IM Distortion (IHF) <0.05%
Acceptable Signal Voltage Range Variable from 250mV to 4.5V (RCA Input)
Protection NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
Equalization (45Hz Punch Bass) Variable from 0dB to +18dB @ 45Hz
Input Impedance 20k ohms
The Blue Rockford PCB are exclusive for the PRO Series of Rockford amplifiers.