Rangemaster ELTSHDC110SG - Manual (Page 15)

INSTALLING THE CHIMNEY HOOD
by pressing it downwards until the two
pieces meet.
3. Connect the two recirculation extension
ducting pipes P1 on to the outlets on
either side of the spigot R, which push
fit into position, by pressing them
horzontally until the two pieces meet.
4. Do not fit the recirculation grilles until
after the chimney has been installed.
FITTING THE TELESCOPIC
CHIMNEY
The chimney stack consists of two sections.
1. To fit the upper chimney section S, first
apply pressure to expand the two side
panels slightly to allow the chimney to
be fitted around the two brackets 2 as
illustrated opposite. Fix the chimney to
the two brackets 2 using four of the
screws provided with the fixing kit.
2. To fit the lower chimney section I, first
apply pressure to expand the two side
panels slightly to allow the chimney to
be fitted around the upper chimney S
and the canopy C as illustrated
opposite. Fix the chimney to the canopy
C using two of the screws provided with
the fixing kit.
3. To fit the two push-fit recirculation grilles
G, insert them one at a time into the
holes on either side of the chimney and
apply slight pressure until they snap
into position. Ensure the grilles are
fitted correctly with one arrow pointing
upwards
and one forwards.
4. When the hood is installed in the
recirculation mode, ensure the
recirculation grilles G, are properly
secured to the inside of the recirculation
ducting as illustrated opposite.
14
12c
8a
2.1
2.2
2
8b
7.2.1
12c