Rockford Fosgate RFX9220M - Manual (Page 22)

22
T
ROUBLESHOOTING
S
YMPTOM
D
IAGNOSIS
R
EMEDY
Source Unit does
not turn on Voltage applied to Red and Yellow
wires is not between 10.8 and 16
volts or there is no voltage present Check battery, connections and fuses and repair or
replace as necessary. If voltage is above +16 volts,
have the electrical system inspected by an
authorized car service center.
Unit is not properly grounded Check wiring and repair as necessary
No backlight
illumination Detachable faceplate not properly
connected Detach faceplate and reinstall into chassis
Speakers pop
when turning
Source Unit
On/Off Auto antenna and remote B+ are
not configured properly Check wiring and repair as necessary. Refer to
“Wiring the System” section of this manual for
further information
Bad component in the signal chain Check connections and bypass all components
between the source unit and the amplifier. Connect
one component at a time to determine the culprit.
Connect this component to the Blue wire and
check for pops. Repair or replace component as
necessary
Tuner fails to
tune any radio Antenna is disconnected Check connections and repair as necessary
General
NOTE: If the error still continues after doing one of the easy remedies, before taking the unit to a service
dealer, try resetting the system by pressing the reset button.
Tuner has poor
reception Antenna is disconnected or not
properly grounded to vehicle Check connections and installation of antenna and
repair or replace as necessary
Antenna cable is intermittent or
damaged Disconnect antenna and test with known working
antenna. If tuner works, check installation and repair
antenna as necessary
Antenna is wrong type for AM/FM
frequencies Consult your local Authorized Rockford Fosgate
Dealer for proper antenna selection
Disc will not load
into Source Unit
(also see error
codes) Voltage applied to Red and Yellow
wires is not between 10.8 and 16
volts or there is no voltage present Check battery, connections and fuses, and repair or
replace as necessary. If voltage is above +16 volts,
have the electrical system inspected by an
authorized car service center
Disc will not
eject
(also see error
codes) Voltage applied to Yellow wire is not
between 10.8 and 16 volts or there
is no voltage present Check battery, connections and fuses, and repair or
replace as necessary. If voltage is above +16 volts,
have the electrical system inspected by an
authorized car service center