Radio Shack 900MHz - Manual (Page 25)

25 TAD Operation
number appears as each message
plays, and the phone announces the day
and time of the call at the end of each
message.
To play all messages after playing the
new messages, press
PLAY/STOP again.
To skip to the next message, press SKIP
during playback. If you know the mes-
sage number of the one you want to
hear, hold down
SKIP until the desired
number appears.
To replay the current message from the
beginning, press
REPEAT . If you press
REPEAT within about 2 seconds (4 sec-
onds during remote operation) after a
message begins playing, the phone re-
plays the previous message.
If you know the message number of the
one you want to hear, hold down
RE-
PEAT until the desired number appears.
ADJUSTING THE TAD’S
VOLUME
To adjust the speaker’s volume, repeat-
edly press
VOLUME
8 8 8 8
or
9 9 9 9
on the
base. The volume setting from 1 (low-
est) to 10 (highest) appears in the mes-
sage counter window.
DELETING MESSAGES
To delete the current message while it is
playing, press
DELETE . The phone
beeps.
To delete all messages on either line at
once, repeatedly press
MSG LINE SE-
LECT until the line indicator for the de-
sired line lights in the message counter
window. Then, while messages are not
playing, hold down
DELETE on the base
until the phone beeps and 0 appears in
the message counter window.
Note: You cannot delete new (unplayed)
messages. If you try to delete all mes-
sages at once while you still have new
messages, the phone sounds a long
beep and deletes old messages only.
SETTING THE REMOTE
OPERATION PIN
The phone’s two-digit remote operation
PIN (personal identification number)
prevents unauthorized remote access to
your messages. The PIN is preset to 80.
Follow these steps to change the PIN to
any number from 00 to 99. The PIN is
common to both lines.
Note: If you wait more than 2 minutes
between each keypress, the phone exits
the PIN setting process. Start again at
Step 1.
1. Hold down PIN until the phone
beeps and 00 appears in the mes-
sage counter window.
2. Press SKIP to set the first digit of the
PIN higher or REPEAT to set it lower.
Then press PIN .
3. Press SKIP or REPEAT to set the
second digit of the PIN, then press
PIN . The phone announces the new
PIN.
4. To check your PIN at any time,
press PIN . The PIN appears in the
message counter window, and the
phone announces it.