Ryobi SS725r - Manual (Page 6)

OPERATING INSTRUCTIONS
6
2. While firmly holding the add-on, push it straight into
the Click-Link® coupler (Fig. 2).
NOTE: Aligning the release button with the guide recess
will help the installation (Fig. 2).
3. Turn the knob clockwise to tighten (Fig. 3).
CAUTION: Lock the release button in the
primary hole and securely tighten the knob
before operating this unit.
OPERATING THE CLICK-LINK® SYSTEM
The Click-Link® system enables the use of these
optional add-ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Hedge Trimmer (Gas units only) . . . . . . . . . . . . . HS720r
Snow Thrower (Gas units only) . . . . . . . . . . . . . . ST720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r
Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . SB720r
Lawn Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
WARNING: Read and understand operator’s
manual for unit to be used with this add-on
prior to operation.
Removing the Add-Ons:
1. Turn the knob counterclockwise to loosen (Fig. 1).
2. Press and hold the release button (Fig. 2).
3. While firmly holding the upper shaft housing, pull the
cutting attachment or add-on straight out of the
Click-Link® coupler.
Installing the Add-Ons:
WARNING: To avoid serious personal injury,
shut unit off before removing or installing
add-ons.
NOTE: To make installing or removing the add-on easier,
place the unit on the ground or on a work bench.
1. Turn the knob counterclockwise to loosen (Fig. 1).
Click-Link ® Coupler Release Button
Guide
Recess Knob
Lower Shaft
Housing
Release Button
Knob
CAUTION: The add-ons with the
Click-Link® system are to be used in the
primary hole unless stated otherwise in the
specific add-ons operator’s manual. Using
the wrong hole could lead to personal injury,
or damage to the unit.
Fig. 1
Fig. 2
Fig. 3
Click-Link ® Coupler
Primary Hole
Upper Shaft
Housing
Check Flex Shaft Engagement Prior to Using
1. Start the unit.
2. Briefly engage and release the trigger.
3. Check that add-on is operating.
4. If the add-on is not operating, remove add-on and
repeat steps for installing the add-on.
5. Recheck operation of add-on attachment.