Reebok Fitness RX 6200 RBTL12920 User Manual

Page 7

4. Raise the treadmill to the storage position (see HOW TO

FOLD THE TREADMILL FOR STORAGE on page 21).

Have a second person hold the treadmill in the upright posi-
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base. Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-
base. Then, attach the U-base with two 3” Bolts (23), two
Base Washers (129), and two U-base Nuts (51). Tip the
treadmill forward if necessary. Tighten the two 2” Bolts.

5. Make sure that all parts are properly tightened before

you use the treadmill. Place a mat beneath the tread-
mill to protect the floor. For your benefit, familiarize your-
self with the information on pages 23 and 24.

Hole

3. (Note: The parts shown in this step may be preassembled

but may need to be adjusted.) With the help of a second per-
son, raise the Frame (55) and hold it. Insert the Left Frame
Guide (68) into the left side of the Frame. Remove the Lock
Knob (67) from the Lock Pin (72). Be sure the Lock Pin
Collar (70) and the Spring (69) are on the Lock Pin. Insert
the Lock Pin into the Frame and the Left Frame Guide.
Press the Latch Insert (5) onto the Frame, with the Lock Pin
in the center hole. Tighten the Lock Knob onto the Lock Pin.

Align the Lock Pin (72) with the hole in the Left Foam Grip
(62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Lock Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert and the Left Frame
Guide. Note: It may be necessary to pull the Lock Knob
(67) to access and tighten the Screws.

129

If you purchase the optional chest pulse sensor (see page
20), follow the steps below to install the receiver and the
short jumper wire included with the chest pulse sensor.

1. Make sure that the power cord is unplugged. Remove the

indicated Screws (40) from the Console Back (117). Remove
the Console Back.

2. Connect the Short Jumper Wire (A) to the wire on the

Receiver (B). Connect the other end of the Short Jumper
Wire to the PULSE jack on the back of the Console (80).

Turn the Receiver (B) so the cylinder is on the side
shown, and hold the Receiver against the back of the
Console (80). Attach the Receiver with the two Small
Screws (C) included with the receiver.

Make sure that no wires are pinched. See step 1.
Reattach the Console Back (117) with the 3/4” Screws (40).
You may discard the other wires included with the receiver.

117

Cylinder