Rockford Fosgate RFX9000 - Manual (Page 9)

I
NSTALLATION
9
STANDARD MOUNT
Installing;
• Mount the Locks for the Installation
Sleeve onto the source unit (use sup-
plied screws).
• Mount the Installation Sleeve into a
secure instrument panel.
NOTE: Make sure to mount the Source
Unit as close to horizontal as
possible for optimum CD Player
performance. Mounting Angles
of up to ±20˚ from horizontal
can be accommodated.
• Bend Appropriate Tabs on all sides of the installation sleeve. See Installation Sheet.
• Install Source Unit by sliding unit into installation sleeve until it clicks into place.
• Mount Back Strap securely behind the instrument panel to prevent source unit vibra-
tion.
• Back strap Screw should be 6mm max (use supplied screw).
• Connect Antenna to antenna jack on rear of source unit.
Removal;
• Disconnect Back Strap from rear of radio (if used).
• Remove Trim Piece from front of radio.
• Insert Release Keys into left and right sides of source
unit to disengage locks.
• Remove Source Unit from installation sleeve with
release keys.
ISO-DIN MOUNT
Installing;
• Remove Trim Piece and Installation Sleeve
from source unit.
• Factory Bracket should align with two
mounting holes on each side of source unit.
• ISO Screws should be 6mm max
(use supplied screws).
• Connect Antenna to antenna jack on rear of
source unit.
• Install Source Unit into instrument panel.
+20
°
-20
°
Horizontal
Lock
Screw
Trim
Sleeve
Back Strap
Trim
Dash
Dash
Screw
Factory Bracket
Release Key