Ryobi TS1550 - Manual (Page 23)

23
ACCESSORIES
WARNING:
To prevent accidental starting that could cause pos-
sible serious personal injury, assemble all accesso-
ries for the saw before connecting it to a power
supply. Disconnecting the miter saw will prevent ac-
cidental starting that could cause serious personal
injury.
INSTALLING THE DUST BAG
See Figure 25.
The dust bag fits over the exhaust port on the upper
blade guard.
Follow these directions to install the dust bag.
■ Remove the dust guide from the exhaust port.
■ Squeeze the two metal clips to open the mouth of the
bag.
■ Slide the bag onto the exhaust port.
■ Release the clips.
The metal ring in the bag should lock in between the
grooves on the exhaust port.
For more efficient operation, empty dust bag when no
more than half full. This will permit better air flow through
the bag.
INSTALLING THE TABLE EXTENSIONS
See Figure 26.
Follow these directions to install the table extensions.
■ Insert the ends of the extensions into the two holes in
each side of the base.
■ Position a clamp bracket under each table extension
beneath the miter table.
■ Secure each clamp bracket with a clamp bracket
screw by threading the screw through the clamp
bracket and tightening it against the bottom of the
miter table.
INSTALLING THE STOP BLOCK
See Figure 27.
The stop block is useful as a stop for cutting multiple
pieces the same length. You can install it on either table
extension on either side of the saw base.
Follow these directions to install the stop block.
■ Slide the stop block on the back arm of either table
extension.
■ Insert the table extension into the saw base.
■ Adjust the stop block the desired distance from the
blade for the cut to be made.
Fig. 25
Fig. 26