Roland DS-5 - Manual (Page 6)

6
Panel Descriptions
Front
fig.
Rear
fig. 1 Digital Input
Coaxial Input Connector (Digital Input)
This is the digital input connector for coaxial cable.
It cannot be used for input of analog audio signals (no sound
is produced).
Optical Input Connector (Digital Input)
This is the digital input connector for optic-fiber cable. Use
commercially available optical cable for audio equipment to
make the connection.
XLR Input Connector (Digital Input)
This is a digital input for AES/EBU professional format
digital audio.
It cannot be used for input of analog audio signals (no sound
is produced).
Bass-reflex Ducts
These are conduits for rich, bass-range reproduction.
Power Switch
This switch turns the power on/off.
Power Indicator
Lights when power is on.
HF Driver
* Do not touch
the diaphragm.
LF Driver
* Do not touch
the speaker cone.
Before turning the power on or off, you must lower
the volume of this unit and your connected device etc.
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
If you need turn off the
power supply completely,
first turn off the POWER
switch, then unplug the
power cord from the power
outlet. Refer to Power
Supply
(p. 5).
Digital In Indicator
This lights up when output is received from a
connected digital device.
Connect the digital-signal output device, set the
"Input Select switch" to DIGITAL INPUT, and set
the "Digital Input select switch" according to the
connector to which the device is attached (Coaxial,
Optical or XLR (AES/EBU)).
* When the connected digital-signal output device
is not powered up, the Digital In indicator does not
light up.
Power cord
1
4
3
2
5
6
7
8
DS-8_7_5_e4.book 6 ページ ２００７年２月２０日 火曜日 午後１時２分