Ryobi HP472 - Manual (Page 12)

12 13
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge.
NOTE: This situation only occurs when continuous use of
the drill causes the batteries to become hot. It does not
occur under normal circumstances. Refer to
“CHARGING
THE BATTERY PACK” for normal recharging of batteries.
If the charging assembly does not charge the battery pack
under normal circumstances, return both the battery pack
and charging assembly to your nearest Ryobi Authorized
Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 3.
n
Place the direction of rotation selector in center po-
sition.
n Locate latches on side of battery pack and depress both
sides to release battery pack from the drill.
n Remove battery pack from the drill.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the drill
and latches into place properly. Improper installa-
tion of the battery pack can cause damage to internal
components.
TO REMOVE BATTERY PACK
See Figure 3.
n
Place the direction of rotation selector in center po-
sition.
n Locate latches on side of battery pack and depress both
sides to release battery pack from the drill.
n Remove battery pack from the drill.
BATTERY
BATTERY
PORT
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 3
LATCHES