Regent Sheffield CMS240W - Manual (Page 2)

2
Congratulations. You have purchased a Regent motion activated detector for outdoor
lighting. When installed properly, this sensor will provide years of convenience and
protection for your home and family.
How it works
Your motion activated detector senses heat from objects such
as people, large animals and automobile engines . When
motion is detected, the lights connected to the detector will
automatically turn on. Once motion has stopped, the lights
will automatically turn off after a preselected time delay. Your
motion detector also has a Night Time On and standard flood-
light feature which will allow your fixture to automatically come
on at night (for a select period of time) or to operate as a
standard floodlight (manual override).
What you need
• Phillips screwdriver
• Outdoor weatherproof silicone caulking
• 1, 2 or 3 hole junction box coverplate (A)
What’s included
• Motion detector (B)
• (3) Wire nuts (C)
Common wall and eave mounting applications
What to know
• For outdoor use only.
• UL and CSA LISTED for wet locations.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. Under Part 15 of the FCC Rules, any changes or modifications to the motion
detector described in this instruction sheet that are not expressly approved by Cooper
Lighting could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
M S 2 4 0 , CMS240 (B ro n ze)
M S 2 4 0 W, CMS240W (W h i t e)
240 degrees
B C
A