Roberts Radio R9994 User Manual

Page 8

Operating your radio FM

1. Turn on the radio by setting the speaker/on/off switch (4) to the

“On” position.

2. For FM stereo reception set the waveband switch (2) to the “FM

Stereo” position. When a station being received is in stereo the
stereo indicator will light.

•

If the FM signal becomes weak or is accompanied by a high level
of background hiss, you may select MONO mode by setting the
switch to the “FM” position.

3. Adjust

the

volume control (1) to the desired level of sound.

Rotating the control anti-clockwise will increase the sound level.

4. Slowly rotate the tuning control (5) until the dial pointer corresponds

to the frequency of the desired station. On FM the tuning scale is
marked in Megahertz (MHz). The tuning indicator (6) will light up
when a station is correctly tuned. Note : the tuning indicator may
not light up when receiving a weak station or if the batteries are
low.

5. For FM reception fully extend the earphone lead and position for

best reception. When using the built in loudspeaker plug the pig
tail aerial into the earphone socket as described on page 3.

6. To switch off your radio slide the speaker/on/off switch (4) to the

“Off” position.

Note: Stereo is only available on FM and when using earphones.