Roksan Audio MK111 - Manual (Page 6)

S E T U P K a n d y Integrated CD Player
CONNECTING MAINS POWER
Please refer to the rear panel view on page 5.The moulded IEC connector of the supplied mains lead should be
plugged into the socket (5) on the rear of the unit first and then plugged into the mains supply. The Mains power
switch (3) is on the rear panel of the CD Player. This switch is normally left on. If the unit is likely to be
unattended for a long period, switch it off and unplug the mains lead from the wall.
SIGNAL CONNECTIONS
ANALOGUE OUTPUT:
The Analogue Output (1) uses Gold plated RCA Phono sockets and should be
connected to the CD or LINE input of your Preamplifier or Amplifier.
The connection is: Right Channel – Red; Left Channel – White or Black.
DIGITAL OUTPUT:
The Digital Output (2) uses a Gold plated RCA Phono socket and should be
connected to an amplifier with a digital input, or to an outboard Digital to Analogue
converter (DAC). Do not connect this socket to an optical input.
IMPORTANT NOTE: For optimum performance it is recommended to use high quality inter-connect cables such
as ROKSAN HDC-02A High Definition Analogue Cable and HDC-01D High Definition Digital Cable.
O P E R A T I O N K a n d y Integrated CD Player
Please refer to the rear panel view on page 5.
SWITCHING ON
The Mains power switch (3) is located on the rear panel of the CD Player. This switch should be left ON for
normal operation. If unattended for a long period, the Mains power should be switched OFF and the lead
disconnected from the power supply.
When switched ON from the rear panel, your Caspian CD Player FL Display will illuminate.
USING THE CONTROLS
Please refer to the front panel view on page 5.
LOADING A DISC
Press the Open/Close Button (1) once to open the disc loading tray. Carefully load a disc into the tray recess with
the label side up. Press the button again to close the tray.
Note: Never load a disc until the drawer has opened fully, or try to close the drawer until you are sure that the
disc is properly seated in the holder recess.
Warped discs should never be played.
The drawer should only be opened using the front panel control. Under no circumstances should you attempt to
open manually.
If no disc is inserted or if the disc is damaged or inserted upside down, the CD Player will remain inoperative and
the display will indicate:
TRACK MIN SEC
Roksan Audio ltd Kandy Integrated CD Player MkIII User Manual
CLASSIFICATION: General Use Version 1.00
All specifications are liable to change without notice. E&OE Page 6 of 11 ENGLISH