RIDGID MaxSelect R885 - Manual (Page 19)

19
50
5
0
OPERATION
OPERATING THE SAW
See Figures 17 - 18.
It is important to understand the correct method for oper-
ating the saw. Refer to the figures in this section to learn
the correct and incorrect ways for handling the saw.
DANGER:
When lifting the saw from the workpiece, the blade
is exposed on the underside of the saw until the
lower blade guard closes. Make sure the lower
blade guard is closed before setting the saw
down.
WARNING:
To make sawing easier and safer, always maintain
proper control of the saw. Loss of control could
cause an accident resulting in possible serious
injury.
To make the best possible cut:

Hold the saw firmly with both hands.
 Avoid placing your hand on the workpiece while making
a cut.
 Support the workpiece so that the cut (kerf) is always to
your side.
 Support the workpiece near the cut.
 Clamp the workpiece securely so that the workpiece will
not move during the cut.
 Always place the saw on the workpiece that is supported,
not the “cut off” piece.
 Place the workpiece with the “good” side down.
 Draw a guideline along the desired line of cut before
beginning your cut.
Fig. 18
RIGHT
50
5
0
Fig. 17
WRONG