RCA RS2130i - Manual (Page 15)

EN
USB Playback
Connecting USB drive to the Main Unit
Insert the USB drive's connector into the main
unit’s USB Jack on the front panel. To disconnect,
unplug the drive.
Selecting USB Mode
Press SOURCE repeatedly to select USB mode.
USB Playback Features
Start and Pause Playback
Press to start and pause playback.
Stop Playback
Press TUNE/PRESET to stop playback. The unit
enters the Navigation mode for 10 seconds
before entering the stop mode.
Skipping Files/Fast Forwarding/Reversing
• Press or to skip to the previous or
next file.
• Press and hold or to fast forward or
reverse through a file while it is playing.
Memory Usage
Press BAND/INFO on the main unit or INFO on
the remote control to view memory usage on the
USB drive.
Radio
Note: Mass Storage Class (MSC) USB
devices of up to 20 GB are compatible
with this unit. Do not connect other USB
devices to this unit.
Selecting Tuner Mode
Press SOURCE to enter Tuner mode.
Selecting Tuner Band
In Tuner mode, press BAND to select between FM
or AM Radio band.
Tune Mode and Preset Mode
The tuner can be in either TUNE or PRESET
mode.
• To select between TUNE and PRESET mode,
press TUNE/PRESET .
• In PRESET mode, "P XX" will be displayed
where "XX" represents the preset number
(1-32).
Tune Mode
In TUNE mode, you can press or to select
desired frequencies.
• Press
or to select frequencies.
• Press and hold or to scan frequencies.
Preset Mode
In PRESET mode, the unit can store up to 32
radio stations in its memory. You can program the
presets in two ways:
• Manually setting the by entering every single
radio station yourself.
• Perform Auto Preset Programming and the
unit can store all available radio stations
automatically in ascending order.
Manually Setting Presets
1. Press TUNE/PRESET to enter TUNE mode.
2. Press or to adjust the desired
frequency.
3. Press PROG once and the most recently
accessed program location flashes on
the display.
4. If a different program location is preferred,
press or to move to the desired preset
number (1-32).
5. Press PROG to store the selected frequency at
that preset.
Auto Preset Programming (FM only)
Press and hold the BAND button for 2 seconds to
scan stations in the FM band. The stations will
then be stored as preset channels. A maximum of
32 stations can be stored. Be careful of your
preset channels being erased accidentally because
the scanning and storing process is automatic
upon pressing the button. You can stop the
automatic scan by pressing any button, but the
erased stations cannot be recovered.
10
RS2130i EN 15/2/07 4:31 PM Page 19