RIDGID MS1290LZ - Manual (Page 35)

35
CUTTING WARPED MATERIAL
See Figures 48 - 49.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in figure 48.
If the warped material is positioned the wrong way as shown
in figure 49, it will pinch the blade near the completion of
the cut.
Fig. 48
RIGHT
WRONG
WARNING:
To avoid kickback and serious personal injury,
never position the concave edge of bowed or
warped material against the fence.
Fig. 49
OPERATION
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other part may create a hazard
or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with
side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a
dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
leum-based products, penetrating oils, etc., come
in contact with plastic parts. They contain chemi-
cals that can damage, weaken or destroy plastic.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
WARNING:
To ensure safety and reliability, all repairs should be
performed by a qualified service technician at an
authorized service center to avoid risk of personal
injury.
Some areas will require infrequent lubrications. You will
need to apply:

Automotive oil directly to the slide bars.
 Light oil or a pressurized light spray oil to the arm pivot
shaft.
 Light oil or a pressurized light spray oil to the torsion
spring.