Revotech Industries sps - Manual

sps
Serial Port Switch User Instructions
®
Welcome
Congratulations on your purchase of a Revo SPS.
These instructions are a guide to using your Revo
serial port switch. Further advice can always be
obtained by contacting the Revo dealer where you
purchased this device or by visiting the Revo website
at: www.revotechnik.com
Your SPS is engineered to serve you well over many
years if properly cared for.
We suggest that you store your SPS in the box to pro-
tect it from damage. Also please avoid getting the
SPS unit wet.
Serial Port Switching is a patent pending technology
from Revo that allows you an unprecedented amount
of control over your modern computerised vehicle.
Note:- Batteries are not required for your SPS.
Operation
All DBW (drive by wire) models
All current model Porsche* and Volkswagen Audi
Group (VAG**) Petrol vehicles use DBW. Ask your
dealer or visit the Revo website at:
www.revotechnik.com to confirm your vehicle specifi-
cation.
All SPS functions are supported by Petrol tur-
bocharged DBW engines.
1. Locate the OBD-II port.
Refer to owner’s manual.
2. Turn ignition on, wait 10 seconds.
3. Select setting on SPS.
4. Connect SPS to OBD-II port.
5. SPS will start beeping after a few seconds.
6. Remove SPS when beeping is active.
7. Repeat steps 3-6 as desired.
8. Start engine.
All Non-DBW (conventional throttle
cable) and Diesel models
SPS switching on Diesel and
non-DBW are the same.
Non-DBW engines can be distinguished by the throttle
cable attached to the throttle body. Ask your dealer or
visit the Revo website at www.revotechnik.com to con-
firm your vehicle specification.
Only SPS 1 function’s are supported on these
engines.
1. Locate the OBD-II port.
Refer to owner’s manual.
2. Turn ignition on, wait 10 seconds.
3. Select setting on SPS.
4. Connect SPS to OBD-II port.
5. SPS will start beeping after a few seconds.
6. Remove SPS when beeping is active.
7. Turn ignition off, wait 10 seconds.
8. Start engine.
SPS Variants
Now we will cover the differences between each SPS
unit. Some of the functions will be described in more
detail as we go along or at the end of this section.
sps 1
Mode 0: SPS inactive.
Mode 1: Stock mode.
Mode 2: Performance mode enabled.
All other positions are disabled.
The Stock mode runs the original factory boost, igni-
tion, and fuelling. This provides stock performance.
Performance mode activates the Revo performance
settings.
For DBW engines, these settings are as default or as
last set by your Revo dealer.
sps 2
When used on Non-DBW and Diesel models, the SPS 2
acts like an SPS 1. For DBW, it performs the following
operations;
Mode 0: SPS inactive.
Mode 1: Stock mode.
Mode 2: Performance mode Enabled - Timing 0.
Mode 3: Performance mode Enabled - Timing 5.
Mode 4: Performance mode Enabled - Timing 9.
Modes 5-7: Not used.
Mode 8: Anti-Theft Enabled.
Mode 9: Anti-Theft Disabled.
Timing 0 is for 95 Ron or 91 (RON+MON)/2 octane fuel.
Timing 5 is for 98 Ron or 93 (RON+MON)/2 octane fuel.
Timing 9 is for unleaded race fuel, any octane over 100.
sps 3
When used on Non-DBW and Diesel models, the SPS
3 acts like an SPS 1. The Mode selector is active, but
the range selector is inactive. For DBW, the SPS 3
performs the following operations;
Mode 0: SPS inactive.
Mode 1: Stock mode.
Mode 2: Performance mode enabled.
Mode 3: Boost adjustment
Mode 4: Fuel adjustment
Mode 5: Timing adjustment
Modes 6-7: Not used
Mode 8: Anti-Theft Enabled.
Mode 9: Anti-Theft Disabled.
Modes 3-5 have the Vario adjustment. This uses the
range selector to make a fine adjustment to the set-
ting.
Vario Range Guidelines
DBW (drive by wire)
Mode 3 Boost adjustment:
Range 0: Valet mode.
Range 1: Stock Boost.
Range 6: Performance Boost.
Range 9: Aggressive Boost.
Mode 4 Fuel Adjustment:
Range 0: Stock Air-Fuel Ratio (AFR).
Range 9: Performance AFR.
Range 9 is the default performance setting. The fuel
adjustment is not available on all cars. Please refer to
our additional tuning guide for more information.
Mode 5 Timing Adjustment:
Range 0-3: 95 Ron or 91 (RON+MON)/2 octane fuel.
Range 4-6: 98 Ron or 93 (RON+MON)/2 octane fuel.
Range 7-9: unleaded race fuel, octane over 100.
Anti-Theft Mode
To enable Anti-Theft modes, an SPS 2 or SPS 3 is
required. This is only available for DBW vehicles.
Do not attempt to start the engine after enabling the
Anti-Theft function at the end of the SPS switching
procedure. Simply turn the ignition off.
When Anti-Theft is enabled, the vehicle will not run.
The engine may catch if starting is attempted, howev-
er the engine will not run normally.
The engine can be started normally after disabling the
Anti-Theft function.
Please note that if there was an attempt to start the
engine while the Anti-Theft was enabled, then it may
stumble when first started again. A simple blip of the
throttle will clear the engine.
SPS 3 Disclaimer
By utilising the advanced user settings on the SPS 3,
the user is responsible for having intimate knowledge
of the vehicle being tuned and the principles of tun-
ing.
Certain situations can lead to conditions that are out-
side of the safe operating range tested by Revo engi-
neers.
The user acknowledges that Revo cannot be held
responsible for the performance and reliability of tun-
ing that has been altered via the SPS 3 advanced
user settings.
Please note that Revo does not make any claims as to
the long term reliability of the car at any high boost
settings. Premium fuel or better should be used for all
boost settings over 6.
Certain combinations of settings can be risky. For a
more complete explanation of the settings, what they
do, how to measure the results, and how to make sure
that your settings are safe, please refer to our supple-
mentary tuning guide available from your Revo dealer
or the Revo website at:
www.revotechnik.com
There are also forums and other resources on the
Revo website where you can seek more information
and discuss these settings. Revo is not responsible
for any advice given by third parties. The user is
responsible for the settings that they utilise.
Warranty
The Revo SPS device is not designed to be user serv-
iceable. Please take it to your Revo dealer for any
service requirements.
Revo will repair or replace your SPS at our discretion,
during the first 12 months of ownership.
Processing is done through the original point of pur-
chase with full receipts and warranty paperwork.
* The Porsche name is used for descriptive purposes
only. No affiliation with Porsche AG is implied.
** The VAG term is used for descriptive purposes only.
No affiliation with Volkswagen Audi Group and/or
Volkswagen Group is implied.
We do hope you enjoy your Revo software. It has
been designed with the user in mind.
Our SPS switching technology allows you to add func-
tionality to that software - these are products that set
us apart from our competitors.
go play!
www.revotechnik.com © Revo 2004