Rogue Audio Vacuum Tube Preamplifier - Manual (Page 3)

3
INTRODUCTION
Congratulations on your purchase decision! We at Rogue Audio truly believe that
our preamplifiers provide the “smartest” value in high-end audio. If you have
never owned a vacuum tube preamplifier you will be thrilled by the silky-smooth
sound and incredible detail that only a tube preamplifier can provide. And with
the Perseus preamplifier, you can be sure that you are getting the very best in tube
amplification. We at Rogue Audio are extremely proud of our products and want
you to enjoy them to their fullest potential. So please, take the time to read
through this short manual so that you can be confident that you have set up your
preamplifier properly.
UNPACKING THE PERSEUS POWER PREAMPLIFIER
Tools required: none
WARNING - This preamplifier uses voltages that could cause injury or
death. Never open the preamplifier while it is plugged in, and always
wait at least one hour after turning the unit off to unplug and open the
unit. Lethal voltages can remain in the electronics after the unit is
unplugged.
The Perseus preamplifier has been painstakingly inspected for cosmetic flaws
during and after assembly. In order not to damage the cosmetic appearance of
your preamplifier it is important that you follow the unpacking instructions
carefully.
1. Remove the small corrugated tube containing the power cord, and remote.
2. Carefully lift the preamplifier out of the box, and remove the foam pads and
plastic bag.
3. The Perseus can be used either with or without the tube cage. To remove the
tube cage, first unscrew 10 cover screws. Lift the cover off, and remove the 4
nuts holding the tube cage in place. Replace the cover prior to use.
4. Save the packing materials. The packing materials and box have been
carefully designed to protect your valuable equipment during shipping so you
don’t want to throw them away.