Reliable I60 - Manual (Page 5)

TROUBLESHOOTING:
PROBLEM EXPLANATION SOLUTION
Does the
steam iron
leak steam
mixed with
water?
1) While filling the tank you
may have poured too much
water into the tank.
2) The iron plate has to be hot
enough to produce dry steam. 1) The problem will go on until the
excess water is emptied. Keep the
steam button depressed until the
water in the tank is at the correct
level.
2) Please check that the temperature
knob is on the right position: “cotton
°°°”
There is
no steam
coming out
of the
iron?
1) The steam knob (where
supplied) might be closed.
2) The iron switch might be off.
3) The boiler switch might be
off.
4) The water might be used up. 1) Open the steam knob
anticlockwise.
2) After the iron switch comes on,
wait for 4 minutes so that the iron
plate gets hot.
3) After the boiler switch comes on,
wait for 10-20 minutes so the boiler
produces steam.
4) Fill it following the instructions
carefully.
Does the
steam leak
dirty
water?
Some dirty water might have
gone into the boiler with the
water and it is given off from
the iron. Fill the empty tank with water
(i300/i500), screw the cap tight,
shake it, unscrew the cap and empty
the tank. Repeat the action until the
water is cleaned. We do not
recommend the use of any additive to
pour in the tank. Before ironing again
spray some steam on a cloth until
clean steam comes out.
How to
clean the
boilers
i700-i702
Clean the boiler frequently by opening
the exhaust valve but only when the
boiler has been disconnected from the
electrical outlet – let pressure go down
first.
How to
clean the
boiler
i300-i500
The use of normal tap water is
recommended. In order to clean the
boiler and remove limestone, rinse it
internally (every 15-20 litres of water
used or every month) with tap water.