Roberts Radio SOUND66 User Manual

Page 16

Manual tuning - FM

1. Fully extend the telescopic aerial. The aerial should be fully extended

and positioned vertically for optimum reception.

2. Press

the

On / Standby button to switch on your sound system.

3. Press

the

FM button to select the FM band.

4. Repeatedly press and release the Tuning Up or Down buttons to

tune to a station. The frequency will change in steps of 50kHz.

If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.

5. When the waveband end is reached the radio will recommence tuning

from the opposite waveband end.

6. Adjust

the

Volume to the required setting.

7. To switch off your sound system press the On / Standby button.

Note:
If you fi nd that FM reception is poor, try repositioning the Telescopic aerial
fully extend and position vertically for optimum reception.
If you fi nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 36 for further details.

2,7