Radio Shack TRC-488 - Manual (Page 18)

18
REPLACING THE FUSES
The TRC-488’s red wire 2-amp in-line
fuse helps protect your CB from power
surges and short-circuits. If the fuse
has blown, replace it with a 2-amp,
fast-acting glass fuse (such as Cat.
No. 270-1007).
The orange wire’s 1-amp in-line fuse
helps protect your CB’s memory chan-
nel backup from power surges and
short-circuits. If the fuse has blown, re-
place it with a 1-amp, fast-acting glass
fuse (such as Cat. No. 270-1005).
Follow these steps to replace either
fuse.
1. Make sure the power source and
CB are both off.
2. Hold the fuse holder by both ends,
push the fuse holder ends
together, then turn counterclock-
wise and release either end. The
fuse holder opens.
3. Replace the fuse with one of the
same type and rating.
4. Push the fuse holder ends
together, then turn the large end
clockwise. The fuse holder closes.
FCC INFORMATION
The Federal Communications Com-
mission (FCC) does not require you to
have a license to operate this CB.
However, the FCC does require you to
read and know Part 95 of
FCC Rules.
These rules apply to the operation of a
class D CB. A copy of these regula-
tions is included with your CB.
Warning: Do not open your CB to
make any internal adjustments. Inter-
nal adjustments and/or modifications
can lead to illegal operation as defined
by Part 95 of
FCC Rules. Such illegal
operation can lead to very serious con-
sequences.
To be safe and sure:
• Never open your CB’s case.
• Never modify your CB.
Your CB might cause TV or radio inter-
ference even when it is operating prop-
erly. To determine whether your CB is
causing the interference, turn off your
CB. If the interference goes away, your
CB is causing the interference. Try to
eliminate the interference by:
• Moving your CB away from the
receiver.
• Contacting your local Radio
Shack store for help.
If you cannot eliminate the interfer-
ence, the FCC requires that you stop
using your CB.
(illus)
21-1585.fm Page 18 Thursday, August 5, 1999 9:39 AM