Ryobi P540 - Manual (Page 3)

3
GENERAL SAFETY RULES
REAd ALL INSTRUcTIONS
BASIc SAFETY PREcAUTIONS
 Do not operate a chain saw with one hand! Use a firm grip
with thumbs and fingers encircling the chain saw handles.
Serious injury to the operator, helpers, bystanders, or any
combination of these persons may result from one-handed
operation. A chain saw is intended for two-handed use.
 Always be aware of what you are doing when using the
chain saw. Use common sense. Do not operate the chain
saw when you are tired, ill, or under the influence of al-
cohol, drugs, or medication.
 Stay alert and pay attention to what you are doing. Use
common sense when using this unit.
 Keep all parts of your body away from the saw chain
when the unit is running.
 Always carry the chain saw by the front handle with the
unit stopped and the guide bar and saw chain positioned
to the rear. When transporting your chain saw, use the
appropriate guide bar scabbard.
 Never let anyone use your chain saw who has not received
adequate instructions in its proper use. This applies to
rentals as well as privately owned saws.
 Before you start the unit, make sure the saw chain is not
contacting any object.
 Stop the chain saw before setting it down. Do not leave
the unit running unattended.
 To avoid accidental starting, never carry the unit with your
finger on the trigger.
 Maintain the unit with care. Keep the cutting edge sharp
and clean for best performance and to reduce the risk
of injury. Follow instructions for
lubricating and changing
accessories. Inspect the battery charger cord periodi-
cally, and if damaged, have it replaced or repaired by an
authorized service dealer.
WARNING:
Do not attempt to operate this unit until you have read
thoroughly and understand completely all instructions,
safety information, etc. contained in this manual. Failure
to comply can result in accidents involving fire, electric
shock, or serious personal injury.
 Keep handles dry, clean, and free of oil and grease.
 Do not operate a chain saw that is damaged, improperly
adjusted, or not completely and securely assembled. Chain
should stop turning when the trigger is released. If the
chain turns after the trigger has been released, have the
unit serviced by your nearest Ryobi service dealer.
 Check for damaged parts. Any part or guard that has been
damaged should be carefully checked to determine that
it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other condi-
tions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced
by an authorized service dealer unless otherwise indicated
elsewhere in this manual.
 All chain saw service, other than the items listed in the
operation and maintenance sections, should be performed
by your nearest Ryobi service dealer.
 Do not use in the rain, snow or wet conditions.
 Always maintain a proper stance. Do not overreach.
 Do not adapt your powerhead to a bow guide or use it
to power any attachments or devices not listed for the
saw.
 Do not cut vines and/or small underbrush.
SAFETY APPAREL
 Wear snug fitting clothing. Always wear heavy, long pants,
overalls, jeans or chaps made of cut resistant material or
ones that contain cut resistant inserts. Wear non-slip safety
footwear. Wear non-slip heavy duty gloves to improve
your grip and to protect your hands. Do not wear jewelry,
short pants, sandals, or go barefoot. Do not wear loose
fitting clothing, which could be drawn into the motor or
catch the chain or underbrush. Secure hair so it is above
shoulder level.
 Wear eye protection which is marked to comply with ANSI
Z87.1 as well as hearing and head protection when oper-
ating this equipment.