Radio Shack Vu Qube V10 - Manual (Page 11)

Vu Qube 11 V10-6/1007
Satellite Position Memory
TO STORE POSITION: Hold down either the Satellite 1 or Satellite 2 button
for at least 2.5 seconds. The LCD will show “P1” or “P2” when button is
released.
TO RECALL POSITION: Hold down either the Satellite 1 or Satellite 2
button for less than 2.5 seconds. The LCD will show “r1” or “r2”.
TO CANCEL RECALL: Press any arrow button to stop moving to a stored
position.
Troubleshooting
If you cannot lock on to the correct satellite, it is most likely that an object
is blocking the signal. If this is the case, move the vehicle to have an
unobstructed view of the southern sky.
ERROR CODES PROBLEM ACTION
E0 Remote is unable
to send commands
to antenna s
SECONDS
s
TURNED
s
is attached to receiver
s
E1 Remote is unable
to receive response
from antenna Move remote closer to antenna
E2 Miscommunication
between remote
and antenna Call Wallace Technologies @
866-802-2228