Ryobi R10520 - Manual (Page 6)

Page 6
SPECIFICATIONS:
DRILL-DRIVER R10510 R10520 R10530
Chuck 3/8 in. Keyless 1/2 in. Keyless 1/2 in. Keyless
Motor DC Motor 12.0 V DC Motor 14.4 V DC Motor 18.0 V
Gear Train Two-Speed Two-Speed Two-Speed
Switch Variable Speed Variable Speed Variable Speed
No Load Speed 0-300 RPM (Low) 0-375 RPM (Low) 0-375 RPM (Low)
0-1200 RPM (High) 0-1350 RPM (High) 0-1350 RPM (High)
Clutch 24 Positions 24 Positions 24 Positions
CHARGER 1400666 1400656 1400667
Input 120 V, 60 Hz, AC only 120 V, 60 Hz, AC only 120 V, 60 Hz, AC only
Charging Voltage 12.0 V 14.4 V 18.0 V
Charge Rate 1 Hour 1 Hour 1 Hour
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest Ryobi Authorized Service Center for electri-
cal check.
DISPOSAL OF THE EXHAUSTED BATTERY
To preserve natural resources, please
recycle or dispose of properly.
This product contains nickel-cadmium
battery. Must be disposed of properly.
Local, state, or federal laws may prohibit
disposal of Nickel-Cadmium batteries in
ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-800-
8BATTERY.
BATTERY PACK PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
WARNING:
Do not attempt to disassemble the battery pack. Fire or injury may result.
RE
CYCLE
1
.8
00.822.88
37
R B R C
N i C d
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields.
GLASSES SAFETY
WEAR YOUR
FORESIGHT IS BETTER
THAN NO SIGHT
WARNING: