Ryobi PBC3046B - Manual (Page 16)

16
STRING REPLACEMENT
See Figures 18, 19, 20 and 21.
1. Stop the engine, disconnect the sparking plug wire.
Hold the string head and unscrew the spool retainer.
Turn clockwise.
2. Remove the spool from the string head. NOTE:
Keep the spring attached to the spool. Remove any
old string remaining on the spool.
3. Cut two pieces of string, each being approximately
2.7 m (9 ft) long.
4. Insert the first string into the anchor hole in the
upper part of the spool. Wind the first string round
the upper part of the spool anticlockwise, as shown
by the arrows on the spool. Place string in the slot
on upper spool flange, leaving about 152 mm (6 in)
extended beyond the slot. Do not overfill. After
winding the string, there should be at least 6 mm
(1/4 in) between the wound string and the outside
edge of the spool.
5. Repeat above step with second string, using the
bottom part of spool. Do not overfill.
6. Replace the spool and the spool retainer. Refer to
“Spool Replacement “ earlier in this manual.
MAINTENANCE
FIRST STRING
Fig. 18
SPOOL
ANCHOR
HOLE
SECOND
STRING
ARROWS ON
SPOOL
Fig. 19
Fig. 20
Fig. 21
FIRST STRING
SLOT
SLOT ARROWS ON
SPOOL
SPRING
BLADE PROTECTOR
See Figures 22.
Always place the blade protector on the blade when the unit
is not in use. The blade protector has clips round the edges
to snap over the blade and keep it in place. Wear gloves and
be cautious when handling the blade.
NOTE: Always remove the blade protector before using the
unit. If not removed, the blade protector could become a
thrown object as the blade begins to turn.
Fig. 22
BLADE
CLIPS
BLADE
PROTECTOR