Rockford Fosgate Prime R500-1 - Manual (Page 10)

10
S
PECIFICATIONS
MODEL- PRIME R500-1
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4 Load Mono 320 Watts x 1
2 Load Mono 500 Watts x 1
Dimensions: Height 2.40" (6.10cm)
Width 7.67" (19.49cm)
Length 16.65" (42.30cm)
Amplifier Fuse Rating (Amp) (2) 30A ATC
Battery Fuse Rating (Amp) External (Not Supplied) 60A
“A” Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
≥85 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
≥105 dB
Crossover Slope 12dB/octave Butterworth
Crossover Frequency Low Pass variable from 40Hz to 130Hz
Frequency Response 20Hz to 20KHz ±1dB
Signal Voltage Adjustment Range Variable from 150mV to 8V (RCA Input)
Remote Punch Level Control (replacement kit) #PLC
Protection Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Punch Bass Variable from 0dB to +12dB @ 45Hz
Input Impedance 20K ohms
Operating Voltage 9 to 16 Volts DC
Balanced Inputs No
CMRR (Common Mode Rejection Ratio) >55dB @ 1KHz
Damping Factor >200
THD+N (Total Harmonic Distortion + Noise) < 1.0% @ 4 ohm
Specifications subject to change without notice
* These specifications are CEA-2006 Compliant