Radio Shack ET-177 - Manual (Page 2)


1997 Tandy Corporation.
All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
INSTALLING THE PHONE
Desk Mounting
Modular Telephone Jack
Wall Mounting
(With or Without Wall Plate
)
ÐÐ
Set the ringer to high or low, or
not to sound at all. You can make
calls with the ringer off, and you
can receive calls if you hear
another phone on the same line
ringing.
Set to TONE or PULSE to match
the type of service you have.
If you have pulse (rotary) service,
you can switch to TONE during a
call to use tone services.
Plug the handset cord into
the jacks on the handset
and base.
Press REDIAL to dial the last number dialed
(up to 31 digits).
Press the switchhook to dis-
connect a call.
Hold down MUTE to keep the
other party from hearing you.
To resume your phone con-
versation, release MUTE.
Press FLASH instead of the
switchhook for special services
such as Call Waiting.
USING THE PHONE
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall jack).
Handset Holder
(Wall Mounting)
1. Slide the clip up.
2. Rotate it and slide it
back into the slot.