Ricoh MP5125A - Manual (Page 12)

Emergency eject hole
This drive has a function that allows the disc to be ejected manually for an emergency case such as
failure of the drive or a power outage.
Caution
This feature is a last measure to be used only in an emergency. Using it excessively
will cause malfunction.
6.
Rear panel
Digital Audio (SPDIF) Output Connector
Provides output to a sound card (Digital signal).
* No digital audio cable is included with the MP5125A.
1.
Analog Audio Output Connector
Provides output to a sound card (Analog signal).
2.
Jumper Connector
This jumper determines whether the drive is configured as a master or slave. Changing the
master-slave configuration takes effect after power-on reset.
3.
IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) interface using a 40-pin flat IDE cable.
Caution
Do not connect or disconnect the cable when the power is on, as this could cause a
short circuit and damage the system. Always turn the power OFF when connecting or
disconnecting the cable.
4.
Power Connector
Connects to the power supply (5 and 12V DC) of the host computer.
Caution
Be careful to connect with the proper way.
Connecting the wrong way may damage the system (and is not guaranteed).
5.