Roberts Radio CR2002 - Manual (Page 12)

11
Manual tuning
1. Press the On/Off button to switch on your radio.
2. Select the required waveband by repeatedly pressing the Band
button. On the FM waveband fully extend the Wire aerial located on
the rear of your clock radio - for MW and LW rotate your clock radio
for best reception.
3. A single press on either the up or down button will change the
frequency in the following increments:-
FM 50kHz
MW 9kHz
LW 3kHz
4. When the waveband end is reached the radio will beep and continue
tuning from the opposite waveband end.
5. Set the Volume and Tone controls to the desired settings.
6. To switch off your radio press the On/Off button.
3 3
1 2
6 5