Royal Sovereign RSH-380 - Manual (Page 4)

RSH-380
6
6. FILM LOADING & THREADING
< Film Threading >
1. Turn the power switch on (“I” position). (The Power
switch is located on the rear the unit)
2. Complete the steps in the "Loading Film" section.
3. Set the desired temperature.
4. Remove the Front Feed Table.
5. Pull down the upper film over the Safety Shield to the
lower film; align and center the lower film to the
upper film and tighten the 2 lower bolt core
screws. (Figure 1)
6. Rewind the upper film until it aligns with the safety cover.
7. Thread the film over the Lower Idle Bar and underneath
the safety shield until the film rests on the upper
roller. Figure 2
8. Put the Front Feed Table back on and close the Safety
Shield. Figure 3
9. Press the Run button and thread the film using the
Laminating Threading Card. Figure 4
< Thermal Film Loading & Threading >
Loading Film
1. Remove the upper and lower film shafts from the
machine and load the films (do not tighten the
core screws at this time)
2. To load the top film, insert 1" core as shown on
Figure 1 (Note the direction of the film wound)
3. Insert the shaft as shown in Figure 2.
Figure 1
Figure 2
Figure 1
Figure 2
Figure 3
Figure 4
Figure 3
Figure 4
Figure 5
4. Insert the core plug on the left hand side. Figure 3
5. Align and center the film and tighten the two core
screws. Figure 4
6. Repeat steps 2 through 4 to load the lower film.
(Please note the direction of the
film wound for the bottom roll). Figure 5
7. Load the upper and lower film shafts on the machine.
7