Ryobi TS230 - Manual (Page 9)

Page 9
45
30
15
0
45
DANGER KEEP H ANDS AWAY FROM BLA DE
45
40
20
10
0
30
10
2 0 0
Fig. 2
FEATURES
KNOW YOUR COMPOUND MITER SAW
See Figure 2.
Before attempting to use your saw, familiarize yourself with
all operating features and safety requirements.
WARNING:
Do not allow familiarity with your saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
13 AMP MOTOR
Your saw has a powerful 13 amp motor with sufficient
power to handle tough cutting jobs. It is made with all ball
bearings, and has externally accessible brushes for ease
of servicing.
10 in. (254 mm) CARBIDE TIPPED BLADE
A 10 in. (254 mm) carbide tipped saw blade is included with
your compound miter saw. It will cut materials up to 3-15/16
in. (100 mm) thick or 5-9/16 (141.3 mm) wide, depending
upon the thickness of the material and the setting at which
the cut is being made.
CUTTING CAPACITIES
When the miter angle (miter table) is set at 0
°
and the
bevel angle is set at 0
°
:
Your saw will cut materials up to a maximum width of
5-9/16 in. (141.3 mm) wide X 2-9/32 in. (57.9 mm)
thick.
It will cut materials up to a maximum thickness of 3-9/16 in.
(90.5 mm) thick X 4 in. (101.6 mm) wide.
When the miter angle (miter table) is set at 45
°
and the
bevel angle is set at 0
°
:
Your saw will cut materials up to a maximum of 3-15/16 in.
(100 mm) wide X 2-9/32 in. (57.9 mm) thick.
When the miter angle (miter table) is set at 90
°
and the
bevel angle is set at 45
°
:
Your saw will cut materials up to a maximum of 5-9/16 in.
(141.3 mm) wide X 1-9/16 in. (39.7 mm) thick.
When the miter angle (miter table) is set at 45
°
and the
bevel angle is set at 45
°
:
Your saw will cut materials up to a maximum of 4 in.
(101.6 mm) wide X 1-9/16 in. (39.7 mm) thick.
LOWER
BLADE GUARD
DUST GUIDE
UPPER
BLADE GUARD
SAW ARM
SWITCH
LOCK-OFF LEVER
FENCE
MITER TABLE
MITER SCALE
MITER
LOCK HANDLE
8 mm WORK
CLAMP SCREW
BEVEL SCALE
BEVEL
LOCK KNOB
SWITCH TRIGGER
ZERO CLEARANCE
THROAT PLATE
NO HANDS
ZONE LABEL
MITER
TABLE FRAME
MITER TABLE
CONTROL ARM
MITER
LOCK PLATE
"NO HANDS ZONE"
BOUNDARY LINE
POSITIVE STOP (S)
WORK CLAMP