beautypg.com

Adjustments, Adjust the transmitter, Step 1 turn on your audio source – Recoton/Advent AW810 User Manual

Page 18: Adjust the transmitter as follows

background image

6

ADJUST THE TRANSMITTER

Adjust the transmitter as follows.

Step 1 Turn ON your Audio Source

(i.e. Stereo Receiver, TV, etc.) so that you

can hear sound coming from the source.

Step 2 Pivot the Antenna (L) to the upright, vertical position.

Step 3 Set the Transmitter “Level”

1. Set the Frequency Control Wheel (J)

to its midpoint.

2. Turn the Output Level Control Wheel (G)

all the way to the left (your left when
looking at the transmitter controls),
as shown.

3. Check status of Audio Level Indicator

Light (F). If it flickers intermittently
(about half the time), proceed to
TUNE THE SPEAKERS.

4. If Audio Level Indicator Light is on solid

red or flickering very rapidly, turn Output
Level Control Wheel slowly back to the
right until light flickers intermittently.

Note: If the light does not flicker, confirm secure connection of the AC Adapter. If
the light still does not flicker, confirm secure connection to the audio source

output.

If, there is still no response, leave the Output Level Control Wheel completely to the
left (as shown) and see the following Note.

Note: If the transmitter is connected to a variable output (i.e. headphone jack, TV
audio out) on the audio source, leave the Output Level Control Wheel turned all the
way to the left (as shown) and adjust the volume on the audio source up or down
as necessary to make the Audio Level Indicator Light flicker intermittently
. If you
are unclear as to the kind of output (variable or fixed) you are using, please see
MORE HELPFUL INFORMATION on following page.

OUTPUT LEVEL

AUDIO IN

L

R

TUNING

CHARGE

DC 18V

Frequency
Control Wheel (J)

Output Level
Control Wheel (G)
(Turn to Left)

Audio Level
Indicator Light (F)