Rogue Audio Rogue Sixty Six - Manual (Page 9)

2) Connecting the power supply - Carefully plug the black six pin
connector coming from the power supply into the rear of the
preamplifier. See Figure 1. Connect the IEC end of the
detachable power cord to the power supply, and plug the
opposite end into the wall outlet.
3) Placement of the preamplifier - The preamplifier is the “brains“
of your system and will have the greatest number of
interconnects. Therefore, the preamplifier should be located
such that it is accessible for cabling between itself and all other
relevant pieces of equipment. NEVER place another piece of
equipment on top of the preamplifier and be sure to leave
adequate space (three inches or more) on the top, sides and
rear for air flow. The external power supply should be
placed as far away as possible from any other components or
cables.
IF THERES A PROBLEM
Below is a checklist of problems that may be encountered.
1) Check that power connections are secure, both main power cord
and 6 pin connections from power supply to preamplifier.
2) Check that all input and output signal connections are secure.
3) Ensure that all tubes are properly seated in sockets.
4) If these do not clear up the problem, please call Rogue Audio
Technical Support at 570-992-9901.
Figure 1
Rogue Sixty Six Owners Manual 2
Output Jacks
Power
Supply
Input Jacks
Phono
Ground
Rogue Sixty Six Owners Manual 7