Radio Shack ET-501 - Manual (Page 2)

MOUNTING THE PHONE
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
ÐÐ
Switch to TONE or PULSE to match the type of service
you have. If you have pulse service, you can switch to
TONE
during a call to use tone services.
Press to end a call without
hanging up the handset.
Press to dial the last number dialed
(up to 31 tone or 32 pulse digits).
Switch the ringer to sound or not to
sound. You can still make calls with
the ringer off, and you can receive
calls if you hear another phone on the
same line ringing.
Press to end a call.
Press for special services.
Plug the handset cord
into the jacks on the
base and handset.
Adjust the receiver’s
volume as desired.
USING THE PHONE
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall jack).

1997 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
Handset Holder
(Wall Mounting)