Subaru Robin Power Products Robin Pump PTX201D - Manual (Page 14)

9
ENGLISH
FRANÇAISE
ESPAÑOL
Take extreme caution when replacing
fuel hose ; gasoline is extremely
flammable.
WARNING
7. FUEL HOSE REPLACEMENT
(See Fig. 7 7-y y)
Replace the fuel hose every 1,000 hours or every
year.
If fuel leaks from fuel hose, replace the fuel hose
immediately.
Flame Prohibited WARNING
8. CHECKING BOLTS, NUTS AND
SCREWS
Retighten loose bolts and nuts.
Check for fuel and oil leaks.
Replace damaged parts with new ones.
1. DISCONNECT THE DELIVERY HOSE
Tilt the pump and drain all water from delivery
hole. Severe damage to pump may result if water
freezes in the pumping chamber.
3. ENGINE OIL (See Fig. 8 8-w w)
Change the engine oil with fresh oil.
Remove the spark plug, pour about 5 cc of
engine oil into the cylinder, slowly pull the
starter handle of the recoil starter 2 or 3 times,
and reinstall the spark plug.
4. CLEAN AND STORE
Slowly pull the recoil starter handle until
resistance is felt and leave it in that position.
Clean the pump thoroughly with an oiled cloth,
put the cover on, and store the pump indoors in
a well ventilated, low humidity area.
2. DISCHARGE FUEL(See Fig. 8 8-q q)
If you do not use the engine more than 1 month,
discharge fuel to prevent gum in the fuel system
and carburetor parts.
Remove the strainer cup, place the strainer
over a container and open the strainer cock to
discharge fuel from the fuel tank.
Remove the drain screw of the carburetor float
chamber and discharge fuel.
PREPARATIONS FOR STORAGE