Radio Shack 15-2143 User Manual

Page 8

Using the Sleep Timer

Code Identification Feature

The Code Identification Feature allows you to identify
the three digit library code stored under your device key.
For example, if you want to find out what three-digit
code is stored under your TV device key, follow the six
steps below:

1. Press and hold the

CODE SEARCH

button until the

red indicator stays on. Release the

CODE SEARCH

button.

2. Press and release the desired mode button (TV,

VCR

, etc.). The red indicator blinks, and then stays

lit.

3. Press and release the

CODE SEARCH

button. The

red indicator blinks off.

4. To find the first digit for the code stored under the

mode button you pressed in step 2, press each
numeric key from 0-9 in turn. When the red indicator
blinks off the number you pressed is the first digit
for the code you are searching for.

5. To find the second digit, repeat step 4. This time

when the red indicator blinks off, this is the second
digit.

6. Repeat step 4 again to find the third digit.

Code Identification

1, 3.

4, 5, 6.

The Sleep button accesses the sleep function of your
TV if it has that feature. If it does not, you can enable
the remote to turn off your TV after a period of 1 to 99
minutes, as shown below. The remote must be in TV
mode to set a Sleep Timer. This feature works even if
your TV does not have a sleep feature.

1. Press and release the

Mode button.

2. Press and hold the

SLEEP

button until red indicator

remains on (occurring after approx. 2-3 seconds).

3. Release the

SLEEP

button.

4. Press and release the numeric buttons (01-99) for the

time required. The red indicator blinks off to indicate
button press acceptance and remains off after the
second button press.

5. Leave your Remote pointing towards

the TV with an unobstructed path.

To cancel the Sleep Timer, press and hold the

SLEEP

key

for 2-3 seconds until the red indicator blinks or press
and release the

POWER

button in TV Mode.