RBH Sound TWO-WAY INDOOR/OUTDOOR A-5AW - Manual (Page 4)

Speaker Placement
3
Installation
The bracket has the ability to be mounted a variety of different ways. It may be mounted
with either nails or screws, horizontally or vertically. There is a hole in the center of the
bracket to allow speaker wire through so it may be properly attached to the speaker. The
cabinet back has a female M6x1.0mm thread for an optional swivel bracket mount.
If working properly, insert the knob covers to complete the installation.
Mounting and Connections
For the following instructions you may need to refer to the Parts Guide section located on
the first page of this manual.
1. The speaker may be mounted either horizontally or vertically. Hold the bracket against
the mounting surface, so you can mark the locations of the mounting holes, and the
wire hole.
2. Drill corresponding pilot holes for the mounting screws or nails and a hole large
enough for the speaker wire to pass through.
3. Pull the speaker wire through the hole and through the bracket, aligning the bracket
with the pilot holes.
4. Use hardware to attach the bracket to the mounting surface.