Razor Pocket Mod Motor Scooter - Manual (Page 7)

6
❑ Battery Care and Disposal
Do not store the battery in temperatures above 75° or below -10° F.
CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-
acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
❑
Charger
The transformer/charger supplied with the Pocket Mod should be regularly examined for damage to the cord, plug,
enclosure and other parts, and, in the event of such damage, the bike must not be charged until it has been repaired or
replaced.
Use ONLY with the recommended charger.
❑ Replacement Parts
The most frequently requested replacement parts (wheels, tires, tubes, batteries and chargers) are available for
purchase at some Razor retail partners or online at www.razorama.com. For other parts contact an authorized Razor
repair center.
❑ Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Send e-mail to [email protected] or call 866-467-2967 for the center nearest you.
WARNING: If a battery
leak develops, avoid contact with
the leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions at
left. If acid comes into contact with
skin or eyes, flush with cool water
for at least 15 minutes and contact
a physician.
REPAIR AND MAINTENANCE
❑ Replacing the Fuse
WARNING:
To prevent shock or short circuit,
please follow the instructions
accordingly and do not skip or
combine any steps.
2
lift up the seat and unscrew the
four corner screws in storage
compartment.
3
Remove seat/storage
compartment.
5
Remove the fuse and replace
with a new one of equal
amperage.
Note: Amperage rating is
located on top of fuse. Fuse must
be replaced with one of equal
amperage.
6
Close the fuse cover. Replace
seat/storage compartment and
secure with the four corner screws.
Amperage
number
1
Make sure the power switch is
turned off.
4
Locate fuse cover on
top of battery assembly. Open the
fuse cover to expose the fuse.