Ryobi RS280VS - Manual (Page 12)

12
OPERATION
ATTACHING THE SANDER TO A VACUUM
See Figure 8.
When sanding for an extended period of time, you can
easily attach the dust collection system of the sander to
a vacuum.
Follow these steps to attach the sander to a vacuum.
■ Unplug the sander.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious injury.
■ Remove the dust bag assembly from the sander.
■ Attach the vacuum hose to the blower exhaust on
the sander.
NOTE: The vacuum hose fits inside the blower
exhaust. The figure illustrates a standard 1-1/4 in.
(3.2 cm) vacuum connection.
■ Connect the sander and vacuum to a power supply.
OPERATING THE SANDER
See Figures 9 and 10.
Follow these steps to operate the sander.
■ Secure the work to prevent it from moving under the
sander.
WARNING:
Unsecured work could be thrown towards the opera-
tor causing injury.
WARNING:
Keep your head away from the sander and the sand-
ing area. Your hair could be drawn into the sander
causing serious injury.
■ Place the sander on the workpiece so that all of the
sanding disc surface is in contact with the workpiece.
CAUTION:
Be careful not to let your hand cover the air vents.
■ Start the sander and move it slowly over the
workpiece.
■ Make successive passes in parallel lines, circles, or
crosswise movements.
NOTE: The front edge of the sander allows for flush
sanding. See Figure 10.
■ Turn the sander off and wait until the sanding disc
comes to a complete stop before removing it from
the workpiece.
Fig. 8
Fig. 9
Fig. 10
BLOWER
EXHAUST
VACUUM
HOSE