Radio Shack Talking 360 - Manual (Page 18)

18 Operation
Pressing DIM once reduces the display's brightness by half; the
voice alert says “Display dim.” Pressing DIM a second time re-
duces the display's brightness by 90%; the voice alert says
“Display dark.” Pressing
DIM a third time returns the display to
full brightness; the voice alert says “Display bright.”
Muting the Audio Alert
While the detector sounds a radar or safety alert signal, press
MUTE to temporarily silence the detector. When you press
MUTE , the voice alert says “Mute on” and M appears. The detec-
tor automatically resets the mute to off 20 seconds after the ra-
dar or safety alert signal stops. Or, press
MUTE again before it
resets, and the voice alert says “Mute off” and M disappears.
Note: The laser alert signal remains audible even if you press
MUTE .
Selecting VG-2 Mode
VG-2 mode is preset to off. To turn on VG-2, hold down MUTE
until the voice alert says “VG-2 on” and VG2-ON appears.
To turn VG-2 off, hold down MUTE until the voice alert says
“VG-2 off” and VG2-OFF appears.
RECEIVING AND IDENTIFYING RADAR,
LASER, AND SAFETY ALERT SIGNALS
When your detector senses a radar signal, X , K , or KA appears.
An alert tone for the type of band detected sounds, and the dis-
play shows the signal strength in numeric form.