Radio Shack ET-205 - Manual (Page 2)

ÐÐ 
1994 Tandy Corporation.
All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
(Back of Telephone)
Set RINGER to HI in a noisy room. Set it to
LOW in a quiet room.
Switch to TONE or PULSE to match the
type of service you have. If you have pulse
(rotary) service, you can switch to TONE
during a call to use tone services.
Press HOLD to hang up the handset without disconnecting the
call. To release a call from hold, lift the handset.
Press FLASH in place of the switchook for special
services such as call waiting.
Press REDIAL to dial the last number dialed (up
to 31 tone or 32 pulse digits).
Press to disconnect a call.
Press for special services.
Indicator — Lights when a
call is on hold. Turns off
when you lift the handset.
Plug the handset cord into the jacks
on the handset and base.
USING THE PHONE MOUNTING THE PHONE
This symbol is intended to alert you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The phone company can charge you for the instal-
lation of the necessary jacks. The USOC number of the
jacks to be installed is RJ11C (RJ11W for a wall jack).
Modular Telephone Jack
Handset Holder
(Wall Mounting)
1. Pull out.
2. Rotate 180°.
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
Short Line Cord
(Not Supplied)
Wall Plate
Line Cord To Jack