ROWENTA GEBRAUCHSANWEISUNG HA 435 - Manual (Page 4)

2 - VOLTAGE
᭿ Before using the appliance for the first time, ensure that your mains voltage corresponds to the
voltage indicated on the appliance.
᭿ Your appliance can be used with a power plug without an earth connection. It is a class II
appliance (dual electrical insulation ).
3 - SAFETY
Heat safety
᭿ In the event of abnormal overheating, a safety device automatically cuts out the appliance. Before
re-using your appliance, you must turn it off by turning the button (A) to
b setting
(mod. HA 435 - HA 475) then unplug the power plug (mod. HA 425 - HA 435 - HA 475) and wait
for the temperature of the appliance to return to normal (approximately 15 min).
Protect Signal: safety beep (mod. HA 475 only)
᭿ Your appliance is fitted with an exclusive audible safety system.
᭿ If your appliance is not working properly, creating a potential risk (appliance covered, tipping over,
grill clogged up, partially or completely blocked), a safety device automatically cuts it out.
᭿ An exclusive electronic system starts up and issues a beep, to warn you that the appliance is
overheating.
᭿ To stop the beep and restart your appliance, you must:
– turn the button (A) to the b setting
– unplug the power plug,
– eliminate the cause of overheating,
– then wait for the temperature to return to normal (approximately 15 min).
᭿ If your appliance starts beeping again, please consult the paragraph entitled “IN THE EVENT OF
PROBLEMS”, at the end of this instruction booklet.
4 - OPERATION
Starting up the appliance and choosing the operating mode:
᭿ Frost-free setting
This setting enables you to automatically maintain the temperature above 0°C in a normally insu-
lated room, whose volume corresponds to the power of your appliance.
To do this, plug in your appliance and turn button (A) so that the “ “ symbol is placed opposite
indicator (B).
᭿ Heating light.
This light (D) only comes on when your appliance is in heating mode.
Mod. HA 425
Your appliance operates at 2400 W as soon as it is plugged into the mains supply, if the thermo-
stat is tripped.
Adjust the temperature setting, according to your own comfort, by turning button (A) (fig. 1):
̈ Setting 9: opposite mark (B) = warmer
̈ Setting 1: opposite mark (B) = cooler.
Mod. HA 435 and HA 475
Your appliance has 3 operating modes. Simply position the symbol corresponding to the chosen
mode opposite mark (B) on the housing (fig. 2).
᭿ The safety rules define three volumes in a bathroom (see diagram 5). this unit must only be ins-
talled in volume 3 of the room so that the selector button (A) cannot be touched by anyone using
the bath or the shower.
NOT 029640 Balnéa 24/09/02 16:33 Page 10