Rangemaster RC77 - Manual (Page 7)

5
Note: The ‘+’ keys have a repeat function: holding the key
pressed down will increase the power setting by one level
every 0.3 seconds.
To reduce the power to a cooking zone select the required
zone, as indicated by the red dot in the display. Press the ‘–‘
key to reduce the power required.
Note: The ‘–’ key has a repeat function: holding the key
pressed down will reduce the power setting by one level
every 0.3 seconds.
To shutdown a cooking zone:
Make sure the required cooking zone has been selected, as
indicated by the red dot in the display. Reduce the power to
0. After three seconds have elapsed the element will switch
off automatically.
Rapid shutdown:
To switch off a selected zone press the ‘+’ and ‘–‘ keys
simultaneously: this will immediately switch off that zone.
Note: After a zone has been switched off an ‘H ’ may appear
in the display. This is a residual heat indicator that shows that
the cooking zone temperature is above 60°C and may still
cause burns. Once the temperature has dropped to below
60°C the ‘H ’ will go out.
To switch off all cooking zones:
All of the cooking zones can be immediately switched off by
pressing the On/Off key. Any ‘hot ‘ zones that were in use will
show an ‘H ’ in the display (Fig.2-8).
Activating the Dual Elements
Select the required cooking zone: a red ‘dot’ will show on the
relevant display. Set the required power level and then press
the Dual Zone key (Fig.2-9). The dual element selected will
activate and an indicator will illuminate in the zone display.
The Dual Zone key will toggle the zones on and off.
Preheat Function
This function allows for rapid heating up of the element to
bring the selected cooking zone up to temperature. Once the
zone is at the required cooking temperature the power level
will reduce automatically to the preset level.
To activate the preheat function:
Select the required cooking zone: a red ‘dot’ will show on the
relevant display.
Press the ‘–’ key to bring the element up to full power.
Press the ‘+’ key to activate the auto function (as indicated by
the ‘A’).
Use the ‘–‘ key to set the preset power level (Fig.2-10).
When the ‘A’ alternates with the selected power setting the
preheat function is in operation.
Art No. 315-0009 H indicator
Fig.2-8
Art No. 315-0011 RC77 dual element
�������������������
������������������
Fig.2-9
Art No. 315-0010 RC77 preheat
Fig.2-10