Ryobi R1801M1 - Manual (Page 17)

17
OPERATION
Fig. 14
When routing a groove wider than the diameter of the
cutter, clamp a straightedge on both sides of the cutlines.
Position both guides parallel to the desired line of cut and
spaced equal distances from the desired edges of the
groove. Rout along one guide; then, reverse direction and
rout along the other guide. Clean out any remaining
waste in the center of the groove freehand.
ROUTING BY FREEHAND
See Figure 14.
When used freehand, your router becomes a flexible and
versatile tool. This flexibility makes it possible to easily
rout signs, relief sculptures, etc.
There are two basic techniques for freehand routing:
■
■ ■ ■ ■ Routing letters, grooves, and patterns into wood.
■
■ ■ ■ ■ Routing out the background, leaving the letters or
pattern raised above the surface.
When freehand routing, we suggest the following:
■
■ ■ ■ ■ Draw or layout the pattern on workpiece.
■
■ ■ ■ ■ Choose the appropriate cutter.
NOTE: A core box or V-groove bit is often used for
routing letters and engraving objects. Straight bits and
ball mills are often used to make relief carvings.
Veining bits are used to carve small, intricate details.
■ ■ ■ ■ ■ Rout the pattern in two or more passes. Make the first
pass at 25% of the desired depth of cut. This will
provide better control as well as being a guide for the
next pass.
NOTE: Do not rout deeper than 1/8 in. per pass.
WARNING:
Do not use large router bits for freehand routing. Use of
large router bits when freehand routing could cause loss
of control or create other hazardous conditions that could
cause possible serious personal injury. When using a
router table, large router bits should be used for edging
only. Do not use router bits that are larger in diameter
than the opening in router subbase for any purpose.