Radio Shack 32-1167 - Manual (Page 8)

7
To erase a programmed sequence during programming,
press
STOP .
C;CEHO C;CEHO C;CEHO C;CEHO
disappears.
To erase a programmed sequence after programming,
press
PROGRAM. Then press STOP .
C;CEHOý C;CEHOý C;CEHOý C;CEHOý
disappears.
To erase a programmed sequence at any time, press OPEN/
CLOSE , or press POWER .
-
#4#1-'
When a microphone is plugged into MIC 1 or MIC 2 , the
system mixes the microphone output with recorded music
from CDs or CDGs. Rotate
MIC VOLUME to a comfortable
listening level, and AUTO VOICE for the best balance
between playback and microphone levels.
Rotate ECHO to add depth and richness to vocals.
5KPIKPI"#NQPI"9KVJ"#"%&1%&)"
1. Press POWER to turn on the system. The POWER
indicator turns on.
2. Load a CD/CDG in the CD compartment.
3. Set AUTO VOICE to the desired position, to enjoy both
the music and original singer’s voice. Whenever you
sing along, the original singer’s voice is cancelled.
4. Press PLAY/PAUSE to start play.
5. Adjust MASTER VOLUME to the desired level.
6. Set the microphone’s ON/OFF switch to ON and rotate
MIC VOLUME to adjust the microphone’s volume.
7. Sing directly into the microphone along with the music.
8. Adjust ECHO for the desired reverberation.
9. When you finish, press STOP on the CD/CDG. Then
press OPEN/CLOSE to open the compartment door and
remove the CD.
10. Set each microphone’s ON/OFF switch to OFF , then
press POWER to turn off the system.