RCA PRO-X33AV - Manual (Page 3)

3
3. Push down the speaker’s red tab to open
the positive (+) terminal and insert the
wire’s other conductor. Release the tab.
4. Using the speaker wire’s coding as a
guide, connect the other end of the
speaker wire to the amplifier’s
corresponding (right or left) speaker
terminals.
MAINTENANCE
To enjoy your PRO-X33AV 2-Way Die-Cast
Mini Speaker for a long time:
• Keep the speaker dry. If it gets wet, wipe
it dry immediately.
• Use and store the speaker only in
normal temperature environments.
• Handle the speaker gently and carefully.
Don’t drop it.
• Keep the speaker away from dust and
dirt.
• Wipe the speaker with a damp cloth
occasionally to keep it looking new.
Modifying or tampering with the speaker’s
internal components can cause a
malfunction and might invalidate its
warranty.
This speaker system has been manufactured
to the specifications of RadioShack and is
covered by a limited warranty from
RadioShack. If your speaker system is not
operating as it should, take it to your local
RadioShack store or call 1-800-THE-SHACK
for assistance.
SPECIFICATIONS
Frequency Response ........... 140–20,000 Hz
Power Handling ................ 15 Watts (RMS)
Maximum Power .......................... 30 Watts
Impedance ................... 8 Ohms (Nominal)
Speaker Complement:
3-Inch High-Compliance
Woofer and 1-Inch Extended
Range, High-Compliance
Balance Drive Tweeter
Dimensions (HWD):
6 1 /
2
Ч
4 1 /
16
Ч
4 5 /
16
Inches
(16.5
Ч
10.4
Ч
11 cm)
Weight ....................................... 2 lb 14 oz
(1.3 kg)
Specifications are typical; individual units
might vary. Specifications are subject to
change and improvement without notice.
40-5000.fm Page 3 Friday, January 7, 2000 10:01 AM