beautypg.com

Assembly and set-up – Razor E100 User Manual

Page 4

background image

3

ASSEMBLy AND SET-UP

q

Attaching the Handlebars

q

Charging the Battery

Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery

prior to use.

• Initial charge time: 18 hours

• Run time: Up to 40 minutes of continuous ride time

• Recharge time: up to 12 hours

• Average battery life: 250 charge/discharge cycles

When the scooter is not in regular

use, recharge the battery at least

once a month until normal use is

resumed.

2

Plug the charger into a wall

outlet. If the lights on charger

do not light up, check the power

to the outlet. If necessary, try a

different outlet.

1

Turn power

OFF before

charging. Plug the charger into

the charger port on the electric

scooter.

Charger

Charger

Plug

Charger

Port

q

Inflating the Tire

The front tire is inflated when shipped, but it invariably may lose some pressure between the point of

manufacturing and your purchase.

1

Using a bicycle style tire

pump equipped for a Schrader-

type valve, inflate the front

tire to the PSI indicated on the

sidewall of the tire.

Note: The pressurized air

supplies found at gasoline

stations are designed to inflate

high-volume automobile tires.

If you decide to use such an

air supply to inflate the tire,

first make sure the pressure

gauge is working, then use very

short bursts to inflate to the

correct PSI. If you inadvertently

over-inflate the tire, release the

excess pressure immediately.

2

Depress the push button (a)

located on the front fork and

insert the handlebar stem until

the button locks securely into

the fork.

3

Adjust the tension of the

quick release to where you can

close the lever all the way to

secure the stem.

1

Open the quick release.

(a)

Note: Make sure the cables/

wires are out of the way before

inserting the stem into the fork.

WARNING: Failure

to recharge the battery at least

once a month may result in

a battery that will no longer

accept a charge.

WARNING: Always

disconnect your scooter from

the charger before cleaning with

liquid.

Note: If your charger does not

look like the one illustrated,

your unit has been supplied

with an alternative charger.

The specifications and charging

procedure would not change.

The charger has a small window

with one LED or two LEDs to

indicate the charge status.

Refer to the illustration on

the charger unit for the actual

“charging” and “charged” status

indications for your model

charger.

Chargers have built-in over-

charge protection to prevent

battery from being over-charged.

Charger will get warm during

use. This is normal for some

chargers and is no cause for

concern. If your charger does

not get warm during use, it does

not mean that it is not working

properly.

This manual is related to the following products: