beautypg.com

Maintenance and repair instructions – Ryobi 510r User Manual

Page 13

background image

MAINTENANCE AND REPAIR INSTRUCTIONS

13

Clevis Pin Clip

Felt Cushion

Clevis Pin

NOTE: Some maintenance procedures may require

special tools or skills. If you are unsure about
these procedures take your unit to an authorized
service dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.

WARNING: To prevent serious injury, never
do maintenance or repairs with unit running.
Always do maintenance and repairs on a
cool unit. Disconnect spark plug wire to
ensure the unit will not start.

Fig. 15

Fig. 16

TINE REMOVAL AND REPLACEMENT

All 4 tines should be replaced at the same time because
they will wear evenly through normal use. Work on one
side at a time.

WARNING: To prevent serious personal
injury, always wear heavy gloves when
handling the tines.

1. Put the On/Off Stop Control in the STOP (O) position

and disconnect the spark plug wire.

2. Remove the clevis pin clips and clevis pins (Fig. 15).

3. Remove the tines and felt cushions from the shaft.

4. Clean and oil the shaft.

5. Replace the tines and felt cushions by reversing

steps 2 and 3 (Fig. 16).

NOTE: When installed correctly, the hubs on the tines

will face each other and the letter “R” stamped
on the tines will appear on the right side of the
cultivator and the letter “L” will appear on the
left side from the normal operating position. It is
important that the tines are installed correctly.

6. Repeat this procedure on the opposite side.

FREQUENCY

MAINTENANCE REQUIRED

REFER TO:

Before Starting Engine

Fill fuel tank with fresh fuel

Page 9-10

Check oil

Page 14

Every 10 Hours

Clean and re-oil air filter.

Page 15

1st Change at 10 Hours

Change oil

Page 14

Every 25 Hours there after

Change oil

Page 14

Every 25 Hours

Clean Spark Arrestor

Page 18

10 hours on new engine

Check rocker arm to valve clearance and adjust as required

Page 16-17

Every 50 Hours

Check rocker arm to valve clearance and adjust as required

Page 16-17

Every 50 Hours

Check spark plug condition and gap

Page 18